PSS Seal offers T-Kits to help facilitate the installation of the PSS Shaft Seal. These T-Kits enable the installer to tee into the raw water discharge hose and plumb water to the hose barb fitting of the PSS Shaft Seal. Some examples of water pick-up points are: between the heat exchanger and riser, between the oil cooler and heat exchanger, and between the water pump and oil cooler.
Before Ordering
Measure the inside diameter of the cooling hose, which you intend to tee off from before ordering.
Here's what comes included with all PSS T-Kits.
Below are the inside hose diameters and the equivalent PSS T-Kit part numbers.
1/2" = #07-KIT-012
3/4" = #07-KIT-034
1" = #07-KIT-100
1-1/4" = #07-KIT-114
1-1/2" = #07-KIT-112